![]() ![]() ![]() To verify the driver installation, open Device Manager When a MOGLabs product is connected to a Windows computer, the computer should automatically download and install the required STM32 Virtual COM Port Driver and then be automatically detected by the appropriate host software package. Now you should be able to connect to the unit as described in the manual, use the provided software, apply firmware updates, etc.10.1.1.1.ĭon’t worry about the DNS server addresses, or Advanced settings. The Default gateway should be the same as in Step 4, except the last number should be 1, i.e. The IP address should be the same as at Step 4, except the last number which should be different (e.g. Select “Use the following IP address” and enter a specific IP address, subnet and default gateway. ![]() Select it and click "Properties" to open the connection settings. A new dialog will open, and there should be an item labelled “Internet Protocol Version 4 (TCP/IPv4)”.Click on the appropriate network connection (see red box in example above).On Windows 7, use WIN-i and then find Network and Sharing Center On the Windows computer, press WIN-x and select Network Connections, then click on “Network and Sharing Center”.After a few seconds, the device will show its IP address on the built-in display, for example the number at the bottom (10.1.1.80) is the IP address of the MWM below.Start the device - either by turning on the power switch or holding down the OK button for a few seconds.For the MWM, power can be provided by USB connection to a computer USB port, or to a USB power adapter. Connect device to Windows computer/laptop via standard ethernet patchcord (RJ45 to RJ45 connector).These instructions assume an MWM but the instructions also apply for other ethernet-enabled MOGLabs devices. However, if you don't have a network you can plug new devices in (either because your institution does not allow unregistered devices, or there just isn’t a network), the easiest approach is to connect an ethernet cable directly between your PC and the MOGLabs device. MOGLabs products will automatically detect the network configuration when plugged in and request an IP address from the network server. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |